Wood tops

18mm veneered MDF board. Matt transparent semi-open pore varnished 0.6mm wood veneer, 0.5mm radius corners, 1mm thick wood veneer edging. Front and back of top are 90° folded to form 50mm high side edges whose grain, being part of the same board, lines up perfectly with the top. 50mm high brushed polished 4mm thick extruded aluminum trim ÿtted on table ends. All tops feature a central 450x120mm cutout to accommodate an extruded aluminum !ap complete with two brush strips. The cable !ap comes either epoxy powder coated or polished and opens on two sides. Under the !ap is a 450Wx120Dx110H steel tray for access to cables and ports. The tray is open ended to easily route cables down to !oor lev el.

Leather tops

18mm melamine faced particle board with 0.5mm radius corners and 0.4mm melamine edging. The outer surface is covered with 1.3mm abrasion resistant leather embellished with matching stitching. 50mm high brushed polished 4mm thick extruded aluminum trim ÿtted on table ends. All tops feature a central 450x120mm cutout to accommodate an extruded aluminum !ap provided with two brush strips. The cable !ap upper surface is covered with the same leather as the top and opens on two sides. Under the !ap is a 450Wx120Dx110H steel tray for access to cables and ports. The tray is open ended to easily route cables down to !oor lev el.

Legs

Slightly angled legs with leg bottom shorter than top. Inner frame made of brushed polished 50x50 and 60x30mm steel hollow rectangular tubes welded together, 3mm and 2mm thick respectively. Leg covers made of 30mm veneered MDF curved boards. Matt transparent semi-open pore varnished 0.6mm wood veneer. Covers can be easily removed and put back into place to better route cables down to !oor lev el via a vertical channel inside the leg. They also feature a lower cutout to let cables out. Each leg comes with two 0-10mm steel manually adjustable levelling feet with round Abs molded scratch-resistant base. Legs are ÿtted to the tops through four L-shaped epoxy powder coated 2mm steel brackets and are secured to the beams using metric-threaded screws. Legs of tables with one top only feature an additional epoxy powder coated 12mm thick steel base provided with felt pads. The base is covered with 1mm brushed stainless steel sheet.

Underdeck metal beams

70x30mm 2mm thick steel hollow rectangular tubes reinforced by 4mm thick steel C-shaped open sections. Both come with epoxy powder coating